putclamp Puts the magnetic trailing edge (TE) clamps onto at the park position, just below the leading edge clamps. If the magnetic clamp sensor is disabled (parameter al tems is zero) then you will be asked if you really want to do this, because it may be the case that the clamps are on the actuator bar, in which case they will be dropped all over the place before the actuator bar is lowered. Trendsetter_VLF Trendsetter_VLF_Auto Platesetter_VLF Trendsetter_400/800_Auto Trendsetter_400/800_Proofing Trendsetter_400/800 Platesetter_3244 putclamp

NVS:

../nvs/al_cal_tecpark.xmlNVS: al tecpark

NVS:

../nvs/al_cfg_ppos.xmlNVS: al ppos

../commands/getclamp.xmlCommand: getclamp

../commands/tec.xmlCommand: tec

..\..\ShowAllErrors.htmFirmware 0 Error Index ..\..\ShowAllCommands.htmFirmware 0 Command Index ..\..\ShowAllNVS.htmFirmware 0 NVS Index Updated: Wed Jul 16 19:39:15 2008 PST